Mercury and Thor Fitness Products

This ultra heavy-duty grappler handle can be used for T-bar rowing, grappler deadlifts, and grappler shrugs. It features five different rowing positions/grip orientations, so you can hammer every section of your upper back with devastating efficiency. The gripping sections are approximately 2 inches in diameter, just thick enough to get a good grip workout, but not so thick that it will significantly limit your rowing, shrugging, or deadlifting poundage. The handle is finished with a textured powder coat for enhanced grip. There is also a thumbscrew to prevent sliding on the barbell collar.

Heavy walled steel construction is used throughout, with a durable textured gray/silver powder coated finish. All tubing ends are sealed with decorative plastic caps for a sharp appearance. The Olympic barbell, Olympic collars, and weight plates are not included (they are shown in the photographs for illustrative purposes only).



Written by Michael Calandra —




September 19, 2020



September 19, 2020

Leave a comment


Attach All Kinds of Handles to your Grappler! New Attachment Collars Introduced!

Check out the "Wrestler's Special" in the Exercise of the Month section to see an example of how to use these collars. Collars are available for both a single handle...

Super Fat Dumbbell Handles Indroduced! 2.4 Inch Thick D.B. Bars for Olympic Plates

Compare the Super Fat Grip Bar directly below with the standard 1-inch dumbbell bar shown further below. With the standard thickness 1-inch bar, the fingers can wrap entirely around the...

Another Unique New Product! The Two-Handed Lever Bar

This bar is featured in our December 2015 Exercise of the Month. Click on that for details on how to use this bar for a rear lever lift. Perform lever lifts...